Volvo 240 - Misc Info

Applies to 1989 Volvo 244 GL (at least)

I am going to put random stuff in here that is helpful to me. Or was once helpful, at least... if I spent any amount of time looking for the information, or couldn't find it and had to figure it out myself, I'll put it here so that I can find it again - or maybe it'll even help someone else out.

ECU codes:

1-1-1 No faults.
1-1-2 ECU.
1-1-3 Fuel injectors.
1-1-3 Heated Oxygen sensor-max enrichment sensed (94-up).
1-1-5 Injector #1.
1-2-1 Mass airflow sensor.
1-2-2 Air temp sensor signal.
1-2-3 Coolant temp sensor signal.
1-2-5 Injector #2.
1-3-1 Ignition system RPM signal.
1-3-2 Battery voltage.
1-3-3 Throttle switch signal (idle).
1-3-5 Injector #3.
1-4-2 ECU faulty.
1-4-3 Knock Sensor signal missing or defective.
1-4-4 Fuel system load signal(missing or defective).
1-4-5 Injector #4.
1-5-3 Rear heated oxygen sensor signal.
1-5-4 EGR system-leakage or excessive flow.
1-5-5 Injector #5.
2-1-2 Oxygen sensor signal(front sensor on 94 and later models).
2-1-3 Throttle switch signal.
2-1-4 Ignition RPM signal erratic.
2-2-1 Heated Oxygen Sensor(Rich mixture/part throttle).
2-2-2 Main relay.
2-2-3 Idle valve signal.
2-2-4 Coolant temp sensor signal.
2-2-5 A/C pressure sensor signal.
2-3-1 Lambda adjustment.
2-3-1 Heated Oxygen sesnor(lean mixture/part throttle) 94-up.
2-3-2 Lamda adjustment.
2-3-2 Adaptive heated O2 sensor control (94-up).
2-3-3 Idle valve-closing signal.
2-3-4 Throttle switch signal missing.
2-4-1 EGR malfunction.
2-4-5 Idle air control valve-closing signal.
3-1-1 Speedometer signal.
3-1-4 Camshaft position signal missing or defective.
3-1-5 EVAP emission control system.
3-2-1 Cold start valve-signal missing.
3-2-2 Airflow meter hot wire.
3-2-4 Camshaft position signal erratic.
3-2-5 ECU memory failure.
3-3-5 TCM request for MIL.
4-1-1 Throttle switch signal faulty or missing.
4-1-3 EGR temp sensor signal incorrect or missing.
4-1-4 Turbo boost regulation.
4-1-6 Turbo boost reduction from TCM.
4-2-5 Temp warning level #1.
4-3-1 EGR temp sensor faulty or missing.
4-3-2 High temp warning inside ECU.
4-3-3 No rear knock sensor signal.
4-3-5 Front heated oxygen sensor - slow response.
4-3-6 Rear heated oxygen sensor compensation.
4-4-3 Catalytic converter efficiency.
4-4-4 Acceleration sensor signal.
4-5-1 Misfire - #1 cylinder.
4-5-2 Misfire - #2 cylinder.
4-5-3 Misfire - #3 cylinder.
4-5-4 Misfire - #4 cylinder.
4-5-5 Misfire - #5 cylinder.
5-1-1 Adaptive oxygen sensor control-lean mixture at idle.
5-1-2 Oxygen integrator at max lean running limit.
5-1-3 High temp warning inside ECU.
5-1-4 Engine cooling fan-low speed signal faulty.
5-2-1 Oxygen sensor preheating-front.
5-2-2 Oxygen sensor preheating- rear.
5-3-1 Power stage-group A.
5-3-2 Power stage-group B.
5-3-3 Power stage- group C.
5-3-4 Power stage- group C.
5-3-5 TC control valve signal.
5-4-1 EVAP valve signal.
5-4-2 Misfire - more than one cylinder.
5-4-3 Misfire - at least one cylinder.
5-4-4 Misfire - more than one cylinder/catalytic converter damage.
5-4-5 Misfire - at least one cylinder/catalytic converter damage.
5-5-1 Misfire - #1 cylinder/catalytic converter damage.
5-5-2 Misfire - #2 cylinder/catalytic converter damage.
5-5-3 Misfire - #3 cylinder/catalytic converter damage.
5-5-4 Misfire - #4 cylinder/catalytic converter damage.
5-5-5 Misfire - #5 cylinder/catalytic converter damage.

Hope this helps someone. My hick.org email address is rixon. Or rixoff on gmail.